Hey,
I have a 2008 Nissan Navara, (spanish built and plastic cover) 4×4 2.5ltr turbo diesel. Long story short, my engine had overheated and I am looking for a price to get my engine re-conditioned and put back together. Are you able to help by giving me a price?
I would like to pull my Evo 9 engine and bring it to you guys to be rebored. Its low on no1 cylinder and getting close to lowest on the other 3 and would like to save some money by pulling it myself . So I would like to bring it to you less head and sump:
1. Then you guys pull down
2. Check all clearances,
3. Report back to me on work needed and size of pistons and crank bearings needed
4. Lets assume rebore with hone for 20 thou over, 85.5
5. pending condition I’d like to reuse my existing crank, motor has done only 76k but would include the usual crank work refinishing for the crank and rod bearings,
6. I’d want carrillo pro h rods, wiseco 1400HD or CP pistons and all ACL bearings installed and everything assembled all back ready for myself to pick up.
There’s a place in villawood called Lamspeed that supplies these parts and have them price listed on their website.
So I would like to understand what the price would be for all work above, without parts. Also are you guys able to source these parts for the same or less than Lamspeed?
Hey,
I have a 2008 Nissan Navara, (spanish built and plastic cover) 4×4 2.5ltr turbo diesel. Long story short, my engine had overheated and I am looking for a price to get my engine re-conditioned and put back together. Are you able to help by giving me a price?
Thanks.
Hi,
I would like to pull my Evo 9 engine and bring it to you guys to be rebored. Its low on no1 cylinder and getting close to lowest on the other 3 and would like to save some money by pulling it myself . So I would like to bring it to you less head and sump:
1. Then you guys pull down
2. Check all clearances,
3. Report back to me on work needed and size of pistons and crank bearings needed
4. Lets assume rebore with hone for 20 thou over, 85.5
5. pending condition I’d like to reuse my existing crank, motor has done only 76k but would include the usual crank work refinishing for the crank and rod bearings,
6. I’d want carrillo pro h rods, wiseco 1400HD or CP pistons and all ACL bearings installed and everything assembled all back ready for myself to pick up.
There’s a place in villawood called Lamspeed that supplies these parts and have them price listed on their website.
So I would like to understand what the price would be for all work above, without parts. Also are you guys able to source these parts for the same or less than Lamspeed?
Have you done many Evo motors?
Thanks guys